Ingco Automatic pump control 10A

The Ingco Automatic Pump Control 10A is a crucial device for automating water pump systems, preventing dry running, and maintaining consistent water pressure. It’s an excellent addition to domestic water supply setups, small irrigation systems, and other applications where a constant water supply is needed without manual intervention.

The most common models are WAPS001 and WAPS002. They typically share similar specifications and functionalities.

Key Features and Specifications (common for Ingco Automatic Pump Control 10A models):

• Rated Voltage: 220-240V~50/60Hz. This ensures compatibility with standard single-phase electrical systems in Kenya.
• Maximum Current: 10A. This indicates the maximum current the control unit can handle. It means it’s suitable for pumps with a power rating up to approximately 1.1 kW or 1100 Watts (since Power = Voltage x Current, 240V x 10A = 2400W, but considering power factor and safety margins, 1100W is a common stated maximum power for 10A controls). Always ensure your pump’s power rating is within this limit.
• Starting Pressure: 1.5 bar. This is the pressure at which the pump will automatically switch on when a tap or outlet is opened and the pressure drops below this threshold.
• Maximum Pressure: 10 bar. This is the maximum pressure the control unit can safely operate under. It doesn’t mean the pump will produce 10 bar, but rather that the control unit can withstand that pressure.
• Pipe Diameter: 1″ x 1″ (inlet and outlet). This is a standard pipe connection size, making it compatible with most domestic water pumps.
• Protection Degree: IP65. This is a robust Ingress Protection rating, meaning the unit is protected against dust ingress and low-pressure water jets from any direction. This makes it suitable for installation in exposed environments, though protecting it from direct heavy rain is still advisable.
• Automatic Operation: The primary function. It automatically starts the pump when pressure drops (indicating water demand) and stops the pump when water flow ceases (indicating no demand).
• Dry-Run Protection: A critical safety feature. If the pump runs out of water to pump (e.g., the tank is empty, or the well has run dry), the control unit will automatically shut off the pump to prevent damage from dry running.
• Built-in Check Valve: Prevents backflow of water, maintaining pressure in the system.
• Pressure Gauge (often included): Some models (like WAPS002) come with an integrated pressure gauge, allowing you to visually monitor the system pressure.